Wednesday, September 10, 2014

more 3D prints

below are some of the 3d prints i did for people who contacted me.
Most are my designs(from solidworks), some are from thingiverse.com.

My development, a gopro clicker, reinforced design, tolerances apropriate for 3d printing
the difference

offcourse it is interchangable with the original


servoarm and rudder shaft support for fila#89
130mm extension for gopros, printed with 100% infill

layer thickness here is 0.2mm for fast printing


gopro frame from thingiverse on a custom mount to slide into the universal dslr flash mount

0.2mm layer again

fittment tested on this olympus, canon 5d and nikon d90 fits perfectly!


this is a samsung galaxy mount combined with the dslr flash adaptor

no clue why the client wanted to attach the gopro and the galaxy to the dslr..

drift-trike wheel, but the nozzle got clogged

gps case for a Naza controled hexacopter
mk1 parts for the helmet swing mount
 I decided stop using 0.2mm layer thickness as the surface finish is much worse compared to 0.15 or 0.1mm layer height.
So from now on i only use those two layer heights for components that don't require a very good surface finish.
0.1mm layer bmw e36 jacking "mushrooms" they hold the cars 1250kg no problem
foglight delete plate for the bmw


vw bus, needs cleaning up

printed this and stuck it to the cealing with hot glue, thingiverse search: cute octo



No comments:

Post a Comment